dimethylaminododecyl-methacrylate has been researched along with Dental-Plaque* in 6 studies
6 other study(ies) available for dimethylaminododecyl-methacrylate and Dental-Plaque
Article | Year |
---|---|
Short-Time Antibacterial Effects of Dimethylaminododecyl Methacrylate on Oral Multispecies Biofilm In Vitro.
Quaternary ammonium compounds constitute a large group of antibacterial chemicals with a potential for inhibiting dental plaque. The aims of this study were to evaluate short-time antibacterial and regulating effects of dimethylaminododecyl methacrylate (DMADDM) on multispecies biofilm viability, reformation, and bacterial composition in vitro. DMADDM, chlorhexidine (CHX), and sodium fluoride (NaF) were chosen in the present study. Topics: Anti-Bacterial Agents; Bacterial Load; Biofilms; Chlorhexidine; Dental Plaque; Methacrylates; Microbial Viability; Microscopy, Electron, Scanning; Quaternary Ammonium Compounds; Streptococcus | 2019 |
Novel antibacterial orthodontic cement containing quaternary ammonium monomer dimethylaminododecyl methacrylate.
Demineralized lesions in tooth enamel around orthodontic brackets are caused by acids from cariogenic biofilm. This study aimed to develop a novel antibacterial orthodontic cement by incorporating a quaternary ammonium monomer dimethylaminododecyl methacrylate (DMADDM) into a commercial orthodontic cement, and to investigate the effects on microcosm biofilm response and enamel bond strength.. DMADDM, a recently-synthetized antibacterial monomer, was incorporated into orthodontic cement at 0%, 1.5%, 3% and 5% mass fractions. Bond strength of brackets to enamel was measured. A microcosm biofilm model was used to measure metabolic activity, lactic acid production, and colony-forming units (CFU) on orthodontic cements.. Shear bond strength was not reduced at 3% DAMDDM (p > 0.1), but was slightly reduced at 5% DMADDM, compared to 0% DMADDM. Biofilm viability was substantially inhibited when in contact with orthodontic cement containing 3% DMADDM. Biofilm metabolic activity, lactic acid production, and CFU were much lower on orthodontic cement containing DMADDM than control cement (p < 0.05).. Therefore, the novel antibacterial orthodontic cement containing 3% DMADDM inhibited oral biofilms without compromising the enamel bond strength, and is promising to reduce or eliminate demineralization in enamel around orthodontic brackets. Topics: Acid Etching, Dental; Anti-Bacterial Agents; Bacterial Load; Biofilms; Composite Resins; Dental Bonding; Dental Enamel; Dental Plaque; Dental Stress Analysis; Humans; Lactic Acid; Materials Testing; Methacrylates; Microbial Viability; Orthodontic Brackets; Quaternary Ammonium Compounds; Random Allocation; Resin Cements; Saliva; Shear Strength; Streptococcus mutans; Stress, Mechanical | 2014 |
Effect of water-ageing on dentine bond strength and anti-biofilm activity of bonding agent containing new monomer dimethylaminododecyl methacrylate.
The objectives of this study were to develop bonding agent containing a new antibacterial monomer dimethylaminododecyl methacrylate (DMADDM) as well as nanoparticles of silver (NAg) and nanoparticles of amorphous calcium phosphate (NACP), and to investigate the effects of water-ageing for 6 months on dentine bond strength and anti-biofilm properties for the first time.. Four bonding agents were tested: Scotchbond Multi-Purpose (SBMP) Primer and Adhesive control; SBMP+5% DMADDM; SBMP+5% DMADDM+0.1% NAg; and SBMP+5% DMADDM+0.1% NAg with 20% NACP in adhesive. Specimens were water-aged for 1d and 6 months at 37°C. Then the dentine shear bond strengths were measured. A dental plaque microcosm biofilm model was used to inoculate bacteria on water-aged specimens and to measure metabolic activity, colony-forming units (CFUs), and lactic acid production.. Dentine bond strength showed a 35% loss in 6 months of water-ageing for SBMP control (mean±sd; n=10); in contrast, the new antibacterial bonding agents showed no strength loss. The DMADDM-NAg-NACP containing bonding agent imparted a strong antibacterial effect by greatly reducing biofilm viability, metabolic activity and acid production. The biofilm CFU was reduced by more than two orders of magnitude, compared to SBMP control. Furthermore, the DMADDM-NAg-NACP bonding agent exhibited a long-term antibacterial performance, with no significant difference between 1d and 6 months (p>0.1).. Incorporating DMADDM-NAg-NACP in bonding agent yielded potent and long-lasting antibacterial properties, and much stronger bond strength after 6 months of water-ageing than a commercial control. The new antibacterial bonding agent is promising to inhibit biofilms and caries at the margins. The method of DMADDM-NAg-NACP incorporation may have a wide applicability to other adhesives, cements and composites. Topics: Adult; Anti-Bacterial Agents; Bacteria; Bacterial Load; Biofilms; Calcium Phosphates; Dental Bonding; Dental Plaque; Dentin; Dentin-Bonding Agents; Humans; Lactic Acid; Materials Testing; Metal Nanoparticles; Methacrylates; Microbial Viability; Microscopy, Electron, Scanning; Microscopy, Electron, Transmission; Nanoparticles; Quaternary Ammonium Compounds; Resin Cements; Saliva; Silver; Stress, Mechanical; Surface Properties; Temperature; Time Factors; Water | 2013 |
Synthesis of new antibacterial quaternary ammonium monomer for incorporation into CaP nanocomposite.
Composites are the principal material for tooth cavity restorations due to their esthetics and direct-filling capabilities. However, composites accumulate biofilms in vivo, and secondary caries due to biofilm acids is the main cause of restoration failure. The objectives of this study were to: (1) synthesize new antibacterial monomers and (2) develop nanocomposite containing nanoparticles of amorphous calcium phosphate (NACP) and antibacterial monomer.. Two new antibacterial monomers were synthesized: dimethylaminohexane methacrylate (DMAHM) with a carbon chain length of 6, and dimethylaminododecyl methacrylate (DMADDM) with a chain length of 12. A spray-drying technique was used to make NACP. DMADDM was incorporated into NACP nanocomposite at mass fractions of 0%, 0.75%, 1.5%, 2.25% and 3%. A flexural test was used to measure composite strength and elastic modulus. A dental plaque microcosm biofilm model with human saliva as inoculum was used to measure viability, metabolic activity, and lactic acid production of biofilms on composites.. The new DMAHM was more potent than a previous quaternary ammonium dimethacrylate (QADM). DMADDM was much more strongly antibacterial than DMAHM. The new DMADDM-NACP nanocomposite had strength similar to that of composite control (p>0.1). At 3% DMADDM in the composite, the metabolic activity of adherent biofilms was reduced to 5% of that on composite control. Lactic acid production by biofilms on composite containing 3% DMADDM was reduced to only 1% of that on composite control. Biofilm colony-forming unit (CFU) counts on composite with 3% DMADDM were reduced by 2-3 orders of magnitude.. New antibacterial monomers were synthesized, and the carbon chain length had a strong effect on antibacterial efficacy. The new DMADDM-NACP nanocomposite possessed potent anti-biofilm activity without compromising load-bearing properties, and is promising for antibacterial and remineralizing dental restorations to inhibit secondary caries. Topics: Anti-Bacterial Agents; Bacterial Load; Biofilms; Bisphenol A-Glycidyl Methacrylate; Calcium Phosphates; Dental Materials; Dental Plaque; Elastic Modulus; Humans; Lactic Acid; Magnetic Resonance Spectroscopy; Materials Testing; Methacrylates; Microbial Sensitivity Tests; Microbial Viability; Nanocomposites; Nanoparticles; Pliability; Polyethylene Glycols; Polymethacrylic Acids; Quaternary Ammonium Compounds; Saliva; Spectroscopy, Fourier Transform Infrared; Streptococcus mutans; Stress, Mechanical | 2013 |
Dental plaque microcosm response to bonding agents containing quaternary ammonium methacrylates with different chain lengths and charge densities.
Antibacterial bonding agents are promising to combat bacteria and caries at tooth-restoration margins. The objectives of this study were to incorporate new quaternary ammonium methacrylates (QAMs) to bonding agent and determine the effects of alkyl chain length (CL) and quaternary amine charge density on dental plaque microcosm bacteria response for the first time.. Six QAMs were synthesized with CL=3, 6, 9, 12, 16, 18. Each QAM was incorporated into Scotchbond multi-purpose (SBMP). To determine the charge density effect, dimethylaminododecyl methacrylate (DMAHDM, CL=16) was mixed into SBMP at mass fraction=0%, 2.5%, 5%, 7.5%, 10%. Charge density was measured using a fluorescein dye method. Dental plaque microcosm using saliva from ten donors was tested. Bacteria were inoculated on resins. Early-attachment was tested at 4h. Biofilm colony-forming units (CFU) were measured at 2 days.. Incorporating QAMs into SBMP reduced bacteria early-attachment. Microcosm biofilm CFU for CL=16 was 4 log lower than SBMP control. Charge density of bonding agent increased with DMAHDM content. Bacteria early-attachment decreased with increasing charge density. Biofilm CFU at 10% DMAHDM was reduced by 4 log. The killing effect was similarly-strong against total microorganisms, total streptococci, and mutans streptococci.. Increasing alkyl chain length and charge density of bonding agent was shown for the first time to decrease microcosm bacteria attachment and reduce biofilm CFU by 4 orders of magnitude. Novel antibacterial resins with tailored chain length and charge density are promising for wide applications in bonding, cements, sealants and composites to inhibit biofilms and caries. Topics: Anti-Bacterial Agents; Bacterial Adhesion; Bacterial Load; Biofilms; Dental Materials; Dental Plaque; Fluorescein; Fluorescent Dyes; Humans; Hydrocarbons, Brominated; Hydrocarbons, Halogenated; Methacrylates; Quaternary Ammonium Compounds; Resin Cements; Saliva; Streptococcus; Streptococcus mutans | 2013 |
Dental primer and adhesive containing a new antibacterial quaternary ammonium monomer dimethylaminododecyl methacrylate.
The main reason for restoration failure is secondary caries caused by biofilm acids. Replacing the failed restorations accounts for 50-70% of all operative work. The objectives of this study were to incorporate a new quaternary ammonium monomer (dimethylaminododecyl methacrylate, DMADDM) and nanoparticles of silver (NAg) into a primer and an adhesive, and to investigate their effects on antibacterial and dentin bonding properties.. Scotchbond Multi-Purpose (SBMP) served as control. DMADDM was synthesized and incorporated with NAg into primer/adhesive. A dental plaque microcosm biofilm model with human saliva was used to investigate metabolic activity, colony-forming units (CFU), and lactic acid. Dentin shear bond strengths were measured.. Minimum inhibitory concentration (MIC) and minimum bactericidal concentration (MBC) of the new DMADDM were orders of magnitude lower than those of a previous quaternary ammonium dimethacrylate (QADM). Uncured primer with DMADDM had much larger inhibition zones than QADM (p<0.05). Cured primer/adhesive with DMADDM-NAg greatly reduced biofilm metabolic activity (p<0.05). Combining DMADDM with NAg in primer/adhesive resulted in less CFU than DMADDM alone (p<0.05). Lactic acid production by biofilms was reduced by 20-fold via DMADDM-NAg, compared to control. Incorporation of DMADDM and NAg into primer/adhesive did not adversely affect dentin bond strength.. A new antibacterial monomer DMADDM was synthesized and incorporated into primer/adhesive for the first time. The bonding agents are promising to combat residual bacteria in tooth cavity and invading bacteria at tooth-restoration margins to inhibit caries. DMADDM and NAg are promising for use into a wide range of dental adhesive systems and restoratives. Topics: Adult; Analysis of Variance; Anti-Infective Agents, Local; Biofilms; Colony Count, Microbial; Dental Bonding; Dental Cements; Dental Plaque; Dental Stress Analysis; Dentin-Bonding Agents; Humans; Lactic Acid; Methacrylates; Nanostructures; Quaternary Ammonium Compounds; Shear Strength; Silver; Statistics, Nonparametric; Tooth Preparation | 2013 |