brine and Rigor-Mortis

The effects of temperature (-1, 4, and 10 degrees C), brine concentration (12% and 25% NaCl), injection volumes, and needle densities were investigated on fillet weight gain (%), salt content (%), fillet contraction (%), and muscle gaping in pre rigor brine-injected fillets of Atlantic salmon (Salmo salar). Increased brine concentration (12% to 25%) significantly increased the initial (< 5 min after injection) and final contraction (24 h after injection) of pre rigor fillets. Increased brine concentration significantly reduced weight gain and increased salt content but had no significant effect on muscle gaping. The temperatures tested did not significantly affect weight gain, fillet contraction, or gaping score. Significant regressions (P < 0.01) between the injection volume and weight gain (range: 2.5% to 15.5%) and salt content (range: 1.7% to 6.5%) were observed for injections of pre rigor fillets. Double injections significantly increased the weight gain and salt content compared to single injections. Initial fillet contraction measured 30 min after brine injection increased significantly (P < 0.01) with increasing brine injection volume but no significant difference in the fillet contraction was observed 12 h after brine injection (range: 7.9% to 8.9%). Brine-injected post rigor control fillets obtained higher weight gain, higher salt content, more muscle gaping, and significantly lower fillet contraction compared to the pre rigor injected fillets. Injection-salting is an applicable technology as a means to obtain satisfactory salt contents and homogenously distribute the salt into the muscle of pre rigor fillets of Atlantic salmon before further processing steps such as drying and smoking.

Topics: Animals; Dose-Response Relationship, Drug; Food Handling; Food Preservation; Food Preservatives; Food Technology; Muscle, Skeletal; Rigor Mortis; Salmo salar; Salts; Seafood; Sodium Chloride

The dynamics of water in postmortem muscle were studied by magnetic resonance microscopy (MRM). Rabbit muscles were arterially injected with 3 and 5 M NaCl brine. T2 and diffusion mapping were performed during the onset of rigor mortis. A wide spread of T2 values and widely differing postmortem evolutions were observed for injected muscles, whereas T2 was spatially homogeneous for intact muscle. Also, highly variable spatial distribution of diffusion coefficients along (Dz) and across (Dx) the muscle fibers was observed and diffusion anisotropy Dz/Dx) was less marked in injected muscles. The results indicate heterogeneity of brine distribution far from the injection site soon after injection. The postmortem evolution of the parameters is discussed in terms of structural changes induced by brine injection. MRM provides insight into how water dynamics respond to different NaCl concentrations inside muscle.

Topics: Animals; Body Water; Magnetic Resonance Imaging; Magnetic Resonance Spectroscopy; Muscle, Skeletal; Rabbits; Rigor Mortis; Salts