sorbitan-monooleate and laponite

The effects of salt on emulsions containing sorbitan oleate (Span 80) and Laponite particles were investigated. Surprisingly, a novel double phase inversion was induced by simply changing the salt concentration. At fixed concentration of Laponite particles in the aqueous phase and surfactant in paraffin oil, emulsions are oil in water (o/w) when the concentration of NaCl is lower than 5 mM. Emulsions of water in oil (w/o) are obtained when the NaCl concentration is between 5 and 20 mM. Then the emulsions invert to o/w when the salt concentration is higher than 50 mM. In this process, different emulsifiers dominate the composition of the interfacial layer, and the emulsion type is correspondingly controlled. When the salt concentration is low in the aqueous dispersion of Laponite, the particles are discrete and can move to the interface freely. Therefore, the emulsions are stabilized by particles and surfactant, and the type is o/w as particles are in domination. At intermediate salt concentrations, the aqueous dispersions of Laponite are gel-like, the viscosity is high, and the transition of the particles from the aqueous phase to the interface is inhibited. The emulsions are stabilized mainly by lipophilic surfactant, and w/o emulsions are obtained. For high salt concentration, flocculation occurs and the viscosity of the dispersion is reduced; thus, the adsorption of particles is promoted and the type of emulsions inverts to o/w. Laser-induced fluorescent confocal micrographs and cryo transmission electron microscopy clearly confirm the adsorption of Laponite particles on the surface of o/w emulsion droplets, whereas the accumulation of particles at the w/o emulsion droplet surfaces was not observed. This mechanism is also supported by the results of rheology and interfacial tension measurements.

Topics: Emulsions; Hexoses; Hydrophobic and Hydrophilic Interactions; Salts; Silicates; Surface-Active Agents

Liquid paraffin-water emulsions were prepared by homogenizing oil phases containing sorbitan oleate (Span 80) and aqueous phases containing layered double hydroxide (LDH) particles or Laponite particles. While water-in-oil (w/o) emulsions are obtained by combining LDH with Span 80, the emulsions stabilized by Laponite-Span 80 are always o/w types regardless of the Span 80 concentration. Laser-induced fluorescent confocal micrographs indicate that particles are absorbed on the emulsion surfaces, suggesting all the emulsions are stabilized by the particles. The difference of the particle-stabilized emulsion type may be explained by comparing particle contact angles and the oil-water interfacial tensions, indicating that more Span 80 molecules are adsorbed on the LDH particles than on Laponite. Apparently, the LDH particles are rendered more hydrophobic by Span 80, resulting in the formation of w/o emulsions. The long-term stability of the emulsions was also compared. Emulsions stabilized by Span 80 alone completely separate into two bulk phases of oil and water after 3 months. However, emulsion stability is greatly enhanced with the addition of LDH or Laponite particles. This synergism was accounted for by an increase of the dilational viscoelasticity modulus of the oil-water interface after particles were added to the aqueous phase. This increase indicates that the gel-like particle layer stays at the oil-water interface and resists emulsion coalescence. Scanning electron microscope (SEM) images display the presence of a firm layer surrounding the emulsion droplets and a three-dimensional particle network which extends into the bulk phase aiding emulsion stability.

Topics: Emulsions; Hexoses; Hydrophobic and Hydrophilic Interactions; Microscopy, Confocal; Microscopy, Electron, Scanning; Molecular Structure; Silicates; Surface-Active Agents; Water