salicylates and 2-nitrotoluene

Although many nitroaromatic compounds have been in nature for only a few decades, bacteria have already evolved the ability to metabolize them. Both horizontal transfer of genes and mutagenesis induced under stressful conditions might facilitate evolution of new catabolic pathways. Nitrotoluene degradation pathways are supposedly derived from an ancestral naphthalene degradation pathway. The 2-nitrotoluene degradation genes in Acidovorax sp. strain JS42 are controlled by the transcriptional activator NtdR, which differs from NagR, the activator of the naphthalene degradation operon in Ralstonia sp. strain U2, by only five amino acids. Both regulators respond to salicylate, an intermediate of naphthalene degradation, but NtdR also recognizes a wide range of nitroaromatic compounds. In this issue of Molecular Microbiology, Ju et al. present results of site-directed mutagenesis of NtdR and NagR and show how the nitrotoluene-responsive regulator NtdR can be generated from a NagR-like ancestor by only a few mutations. The reconstructed hypothetical pathway for the evolution of NtdR from NagR demonstrates stepwise broadening of the effector range of the evolving protein without loss of the original activity. These results provide strong evidence for the idea that promiscuity of proteins is an important step in the evolution of new functions.

Topics: Bacterial Proteins; Biotransformation; Comamonadaceae; Evolution, Molecular; Metabolic Networks and Pathways; Mutagenesis, Site-Directed; Naphthalenes; Ralstonia; Salicylates; Toluene

The use of two methods in tandem, single-sided membrane introduction mass spectrometry (SS-MIMS) and fiber introduction mass spectrometry (FIMS), is presented as a technique for field analysis. The combined SS-MIMS-FIMS technique was employed in both a modified commercial mass spectrometer and a miniature mass spectrometer for the selective preconcentration of the explosive simulant o-nitrotoluene (ONT) and the chemical warfare agent simulant, methyl salicylate (MeS), in air. A home-built FIMS inlet was fabricated to allow introduction of the solid-phase microextraction (SPME) fiber into the mass spectrometer chamber and subsequent desorption of the trapped compounds using resistive heating. The SS-MIMS preconcentration system was also home-built from commercial vacuum parts. Optimization experiments were done separately for each preconcentration system to achieve the best extraction conditions prior to use of the two techniques in combination. Improved limits of detection, in the low ppb range, were observed for the combination compared to FIMS alone, using several SS-MIMS preconcentration cycles. The SS-MIMS-FIMS response for both instruments was found to be linear over the range 50 to 800 ppb. Other parameters studied were absorption time profiles, effects of sample flow rate, desorption temperature, fiber background, memory effects, and membrane fatigue. This simple, sensitive, accurate, robust, selective, and rapid sample preconcentration and introduction technique shows promise for field analysis of low vapor pressure compounds, where analyte concentrations will be extremely low and the compounds are difficult to extract from a matrix like air.

Topics: Air Pollutants; Chemical Warfare Agents; Explosions; Mass Spectrometry; Miniaturization; Salicylates; Toluene; Volatilization