plutonium-dioxide and goethite

Heterogeneous reduction of actinides in higher, more soluble oxidation states to lower, more insoluble oxidation states by reductants such as Fe(II) has been the subject of intensive study for more than two decades. However, Fe(II)-induced reduction of sparingly soluble Pu(IV) to the more soluble lower oxidation state Pu(III) has been much less studied, even though such reactions can potentially increase the mobility of Pu in the subsurface. Thermodynamic calculations are presented that show how differences in the free energy of various possible solid-phase Fe(III) reaction products can greatly influence aqueous Pu(III) concentrations resulting from reduction of PuO₂(am) by Fe(II). We present the first experimental evidence that reduction of PuO₂(am) to Pu(III) by Fe(II) was enhanced when the Fe(III) mineral goethite was spiked into the reaction. The effect of goethite on reduction of Pu(IV) was demonstrated by measuring the time dependence of total aqueous Pu concentration, its oxidation state, and system pe/pH. We also re-evaluated established protocols for determining Pu(III) {[Pu(III) + Pu(IV)] - Pu(IV)} by using thenoyltrifluoroacetone (TTA) in toluene extractions; the study showed that it is important to eliminate dissolved oxygen from the TTA solutions for accurate determinations. More broadly, this study highlights the importance of the Fe(III) reaction product in actinide reduction rate and extent by Fe(II).

Topics: Ferric Compounds; Ferrous Compounds; Iron Compounds; Minerals; Oxidation-Reduction; Plutonium; Thermodynamics

Changes in aqueous- and solid-phase plutonium oxidation state were monitored over time in hematite (alpha-Fe2O3) and goethite (alpha-FeOOH) suspensions containing 239Pu(V)-amended 0.01 M NaCl. Solid-phase oxidation state distribution was quantified by leaching plutonium into the aqueous phase and applying an ultrafiltration/solvent extraction technique. The technique was verified using oxidation state analogues of plutonium and sediment-free controls of known Pu oxidation state. Batch kinetic experiments were conducted at hematite and goethite concentrations between 10 and 500 m2 L(-1) in the pH range of 3-8. Surface-mediated reduction of Pu(V) was observed for both minerals at pH values of 4.5 and greater. At pH 3 no adsorption of Pu(V) was observed on either goethite or hematite; consequently, no reduction was observed. For hematite, adsorption of Pu(V) was the rate-limiting step in the adsorption/reduction process. In the pH range of 5-8, the overall removal of Pu(V) from the system (solid and aqueous phases) was found to be approximately second order with respect to hematite concentration and of order -0.39 with respect to the hydrogen ion concentration. The overall reaction rate constant (k(rxn)), including both adsorption and reduction of Pu(V), was 1.75+/-2.05 x 10(-10) (m(-2) L)(-2.08) (mol(-1) L)(-0.39) (s(-1)). In contrast to hematite, Pu(V) adsorption to goethite occurred rapidly relative to reduction. At a given pH,the reduction rate was approximately independent of the goethite concentration, although the hydrogen ion concentration (pH) had only a slight effect on the overall reaction rate. For goethite, the overall reaction rates at pH 5 and pH 8 were 6.0 x 10(-5) and 1.5 x 10(-4) s(-1), respectively. For hematite, the reaction rate increased by 3 orders of magnitude across the same pH range.

Topics: Adsorption; Ferric Compounds; Hydrogen-Ion Concentration; Iron Compounds; Kinetics; Light; Minerals; Oxidation-Reduction; Plutonium; Ultrafiltration