nitrogenase and methylformamide

The reaction of FeCl(2) or FeCl(3) with sodium ethanethiolate (SEt) in N-methylformamide (NMF) has been reevaluated to rectify a previous Fe(II) oxidation artifact. On titrating Fe(II) with EtS(-) concentrations up to 12 mol Eq, new features in the UV/vis spectrum (epsilon(344)=(3.1+/-0.2)x10(3) M(-1) cm(-1); epsilon(486)=(4.5+/-0.1)x10(2) M(-1) cm(-1)) indicated that the first observable step was the formation of a single complex different from the known tetrahedral tetrathiolate, [Fe(SEt)(4)](2-) . As the EtS(-) concentration increased past 12.5 mol Eq the UV/vis spectrum gradually transformed to that of [Fe(SEt)(4)](2-) (lambda(max)=314 nm). A Hill-formalism fit to the titration data of the initially formed complex indicated cooperative ligation by three ethanethiolate ions, with K(coop)=(1.7+/-0.1)x10(3) M(-3) and Hill "n"=2.4+/-0.1 (r=0.997). The 3:1 EtS(-)-Fe(II) complex is proposed to be [Fe(2)(SEt)(6)](2-). Titration of Fe(III) with EtS(-) showed direct cooperative formation of [Fe(SEt)(4)](-) [epsilon(340)=(3.4+/-0.5)x10(3) M(-1) cm(-1)] with a Hill-formalism K(coop)=(4.3+/-0.1)x10(2) M(-4) and a Hill coefficient "n"=3.7+/-0.2 (r=0.996). Further ligation past [Fe(SEt)(4)](-) was observed at EtS(-) concentrations above 35 mol Eq. The Fe(III) Hill constants are at variance with our previous report. However, the UV/vis spectrum of Fe(III) in NMF solution was found to change systematically over time, consistent with a slow progressive deprotonation of [Fe(nmf)](3+). The observed time-to-time differences in the equilibrium chemistry of Fe(III) with ethanethiolate in NMF thus reflect variation in the microscopic solution composition of FeCl(3) in alkaline NMF solvent. These results are related to the chemistry of nitrogenase FeMo cofactor in alkaline NMF solution.

Topics: Azotobacter vinelandii; Chlorides; Ferric Compounds; Ferrous Compounds; Formamides; Iron; Models, Molecular; Nitrogenase; Oxidation-Reduction; Solutions; Spectrum Analysis; Sulfhydryl Compounds

Equilibrium titrations in N-methylformamide (NMF) of G-25 gel filtered (ox)-state FeMo cofactor [FeMoco(ox)] from Azotobacter vinelandii nitrogenase were carried out using sodium ethanethiolate and followed using UV/Vis absorption spectroscopy. For Fe-Moco(ox), a non-linear least squares (NLLSQ) fit to the data indicated a strong equilibrium thiolate-binding step with Keq = 1.3+/-0.2x10(6) M(-1). With 245 molar excess imidazole, cooperative binding of three ethanethiolates was observed. The best NLLSQ fit gave Keq=2.0+/-0.1x10(5) M(-2) and a Hill coefficient n=2.0+/-0.3. A Scatchard plot of these data was concave upward, indicating positive cooperativity. The fit to previously published data involving benzenethiol titration of the one-electron reduced (semi-reduced) cofactor, FeMoco(sr), as followed by EPR required a model that included both a sub-stoichiometric ratio of thiol to FeMoco(sr) and about five cooperative ligand binding sites. These constraints were met by modeling FeMoco(sr) as an aggregate, with fewer thiol binding sites than FeMoco(sr) units. The best fit model was that of FeMoco(sr) as a dodecamer with five cooperative benzenethiol binding sites, yielding a thiol binding constant of 3.32+/-0.09x10(4) M(-4.8) and a Hill coefficient n=4.8+/-0.6. The results of all the other published ligand titrations of FeMoco(sr) were similarly analyzed successfully in terms of equilibrium models that include both cooperative ligand binding and dimer-level aggregation. A possible structural model for FeMoco aggregation in NMF solution is proposed.

Topics: Cyanides; Formamides; Imidazoles; Ligands; Models, Chemical; Molybdoferredoxin; Nitrogenase; Phenols; Solvents; Spectrophotometry, Ultraviolet; Sulfhydryl Compounds; Titrimetry

Electrochemical and EPR spectroscopic experiments demonstrate that the isolated iron-molybdenum cofactor from the molybdenum-iron protein of nitrogenase from Azotobacter vinelandii exists in multiple forms in both its oxidized and semi-reduced states. The particular forms found in either oxidation state appear to be a function of the acid/base status of the solvent, N-methylformamide. In "alkaline" N-methylformamide, a single, detectable form of iron-molybdenum cofactor is observed for both oxidized and semi-reduced states. The semi-reduced form, termed R(s-r), is the one previously recognized with an S = 3/2 EPR spectrum with apparent g values of 4.6, 3.4, 2.0. Its oxidized counterpart, termed B(ox), is characterized electrochemically by a differential pulse voltammetric reduction peak at -0.37 V versus the normal hydrogen electrode. In "acidic" solvent, two distinct, previously unrecognized redox pairs of iron-molybdenum cofactor forms exist. The two semi-reduced forms, N(s-r) and W(s-r), are characterized by EPR spectra with g = 4.5, 3.6, 2.0 and g = 4.9, 3.1, 1.9, respectively. Their oxidized counterparts, A(ox) and C(ox), have differential pulse voltammetric reduction peaks at -0.32 and -0.43 V versus the normal hydrogen electrode, respectively. Manipulations of either the isolation protocol or the sample conditions affects both the type and distribution of forms present. Each form likely corresponds to a biologically significant state of the cofactor cluster within the protein.

Topics: Azotobacter; Electron Spin Resonance Spectroscopy; Ferredoxins; Formamides; Indicators and Reagents; Molybdoferredoxin; Nitrogenase; Oxidation-Reduction

A convenient and rapid method of obtaining the cofactor of nitrogenase (FeMoco) with a low and apparently limiting Fe/Mo ratio has been developed. FeMoco can be extracted from the MoFe protein bound to DEAE-cellulose. The cofactor is eluted in either N-methylformamide (NMF), N,N-dimethylformamide (DMF), or mixtures of these solvents by use of salts such as Et4NBr,Bu4NBr,Ph4PCl, and Ph4AsCl. The method is simple, is rapid (45 min), yields concentrated cofactor, and, unlike the original method [Shah, V. K., & Brill, W. J. (1977) Proc. Natl. Acad. Sci. U.S.A. 74, 3249-3253] which requires anaerobic centrifugation, is easily scaled up. Furthermore, it gives yields of cofactor in excess of 70%. Its disadvantages are a high Fe:Mo ratio when DMF is the extracting solvent and a high salt concentration in the resultant FeMoco solution. These disadvantages are easily overcome by removing excess Fe by pretreating the cofactor with bipyridyl while still on the column. This gives Fe:Mo ratios of (6 +/- 1):1 (11 trials) with specific activities ranging from 170 to 220 nmol of C2H4/[min.(nmol of Mo)]. Chromatography on Sephadex LH-20 removes ca. 99% of the excess salt. The adsorption of MoFe protein to DEAE-cellulose seems to facilitate denaturation by organic solvents so that pretreatment of the protein with acid, used in earlier methods, is unnecessary. There is an apparent dependence on the charge density of the anion employed for elution of FeMoco bound to DEAE-cellulose, such that Cl- greater than Br- much greater than I-, PF6- is the order of effectiveness of the Bu4N+ salts of these anions.(ABSTRACT TRUNCATED AT 250 WORDS)

Topics: Anions; Cations; Chromatography, DEAE-Cellulose; Dimethylformamide; Ferredoxins; Formamides; Iron; Molybdenum; Molybdoferredoxin; Nitrogenase; Solubility

The reaction of the iron-molybdenum cofactor with thiolate and the redox behavior of the iron-molybdenum cofactor-thiolate complex have been studied by 19F NMR using p-CF3C6H4S- as the reporter ligand. These experiments give results different from those produced by other methods which have been performed near 4 K rather than at ambient temperature. Specifically, these data show that the iron-molybdenum cofactor-thiolate complex is not the product of an irreversible reaction. Rather, the complex is in dynamic equilibrium with the free iron-molybdenum cofactor and free thiolate. Models of the reactions of nitrogenase may need to take this temperature-dependent difference into account because the lability of the iron-molybdenum thiolate bond means its making and breaking could be involved in substrate binding or reduction. The 19F NMR results reported here also show that the S = 3/2 state of the iron-molybdenum cofactor-thiolate complex can be easily and reversibly oxidized by one electron. However, electron exchange between the oxidized and reduced states of the complex is quite slow at approximately 1 mM. Based on low temperature spectroscopic studies, the oxidized iron-molybdenum cofactor-thiolate complex was expected to be diamagnetic. Isotropically shifted NMR spectra of the oxidized cofactor samples at 240-320 K, however, indicate at least partial population of a paramagnetic state, possibly with S = 1.

Topics: Binding Sites; Electron Spin Resonance Spectroscopy; Ferredoxins; Fluorine; Formamides; Magnetic Resonance Spectroscopy; Molybdoferredoxin; Nitrogenase; Oxidation-Reduction; Sulfhydryl Compounds