major-coat-protein--pseudomonas-phage-pf3 and 1-2-dioleoyl-sn-glycero-3-phosphoglycerol

We have investigated the influence of the different lipid classes of Escherichia coli on Sec-independent membrane protein insertion, using an assay in which a mutant of the single-spanning Pf3 coat protein is biosynthetically inserted into liposomes. It was found that phosphatidylethanolamine and other non-bilayer lipids do not have a significant effect on insertion. Surprisingly, the anionic lipids phosphatidylglycerol and cardiolipin stimulate N-terminal translocation of the protein, even though it has no charged amino acid side chains. This novel effect is general for anionic lipids and depends on the amount of charge on the lipid headgroup. Since the N-terminus of the protein is at least partially positively charged due to a helix dipole moment, apparently negatively charged lipids can stimulate translocation of slightly positively charged protein segments in a direction opposite to the positive-inside rule. A mechanism is proposed to explain these results.

Topics: Amino Acid Sequence; Capsid; Capsid Proteins; Cardiolipins; Escherichia coli; Lipid Bilayers; Liposomes; Membrane Lipids; Molecular Sequence Data; Phosphatidylcholines; Phosphatidylglycerols; Protein Transport

The Pf3 major coat protein of the Pf3 bacteriophage is stored in the inner membrane of the infected cell during the reproductive cycle. The protein consists of 44 amino acids, and contains an acidic amphipathic N-terminal domain, a hydrophobic domain, and a short basic C-terminal domain. The mainly alpha-helical membrane-bound protein traverses the membrane once, leaving the C-terminus in the cytoplasm and the N-terminus in the periplasm. A cysteine-scanning approach was followed to measure which part of the membrane-bound Pf3 protein is inside or outside the membrane. In this approach, the fluorescence probe N-[(iodoacetyl)amino]ethyl-1-sulfonaphthylamine (IAEDANS) was attached to single-cysteine mutants of the Pf3 coat protein. The labeled mutant coat proteins were reconstituted into the phospholipid DOPC/DOPG (80/20 molar ratio) and DOPE/DOPG (80/20 molar ratio) model membranes. We subsequently studied the fluorescence characteristics at the different positions in the protein. We measured the local polarity of the environment of the probe, as well as the accessibility of the probe to the fluorescence quencher acrylamide. The results of this study show a single membrane-spanning protein with both the C- and N-termini remaining close to the surface of the membrane. A nearly identical result was seen previously for the membrane-bound M13 coat protein. On the basis of a comparison between the results from both studies, we suggest an "L-shaped" membrane-bound model for the Pf3 coat protein. DOPE-containing model membranes revealed a higher polarity, and quenching efficiency at the membrane/water interface. Furthermore, from the outside to the inside of the membrane, a steeper polarity gradient was measured at the PE/PG interface as compared to the PC/PG interface. These results suggest a thinner interface for DOPE/DOPG than for DOPC/DOPG membranes.

Topics: Amino Acid Sequence; Bacteriophage M13; Capsid; Capsid Proteins; Cysteine; Inovirus; Membrane Proteins; Molecular Sequence Data; Mutagenesis, Site-Directed; Naphthalenesulfonates; Phosphatidylcholines; Phosphatidylethanolamines; Phosphatidylglycerols; Phospholipids; Pseudomonas aeruginosa; Pseudomonas Phages; Spectrometry, Fluorescence; Virus Assembly