lithium-chloride and formamide

Traditional RNA isolation methods use chaotropic agents and anionic detergents to lyse cells and solubilize nucleic acids. In contrast, the cationic surfactant, Catrimox-14, lyses cells and simultaneously precipitates RNA, thereby protecting it from RNases. We describe and compare four methods for extracting RNA from cultured cells that differ in the technique used to extract the RNA from the precipitate. The first uses a high-salt solution (guanidinium isothiocyanate). In the second, the RNA is extracted with a polar solvent (formamide). The third involves conversion of the RNA to the sodium salt by treatment of the precipitate in situ with sodium acetate in ethanol. The fourth uses 2 M lithium chloride to convert the RNA in the pellet to the lithium salt in situ. We applied these methods to human leukemia cells growing in culture and each method resulted in excellent yields of RNA (typically 23 micrograms/million K562 cells, 13 micrograms/million HL-60 cells) over a wide range of cell concentrations (1 x 10(5) - 3 x 10(7)/ml) and of good to excellent quality as judged by agarose electrophoresis and UV absorbance data (OD260/280 1.90-2.05). The advantages and limitations of each method are discussed.

Topics: Acetates; Acetic Acid; Cations; Detergents; Electrophoresis, Agar Gel; Formamides; Guanidines; Humans; Isothiocyanates; Leukemia, Erythroblastic, Acute; Leukemia, Promyelocytic, Acute; Lithium Chloride; Quaternary Ammonium Compounds; RNA, Neoplasm; Trimethyl Ammonium Compounds; Tumor Cells, Cultured

Since the salting-in agents guanidinium chloride, urea, and lithium perchlorate increase the surface tension of water, the salting-in phenomenon does not reflect easier cavity formation in water. Therefore, these salting-in agents must be directly contributing to the solvation of a solute such as benzene in water, probably by a direct solvation interaction. The increased surface-tension effects do not overbalance these solvation effects since they are smaller than the large surface-tension increases with lithium chloride, a typical salting-out agent. The salting-in agent tetra-n-butylammonium chloride differs in that it lowers the surface tension of water. Thus, it probably contributes both to easier cavity formation and to direct solvation of the substrate. The previous findings that most salting-in agents switch to become salting-out agents in other polar solvents such as ethylene glycol and formamide but that tetra-n-butylammonium chloride does not switch in these solvents can be understood in terms of relative polarities.

Topics: Benzene; Chlorides; Ethylene Glycol; Ethylene Glycols; Formamides; Guanidine; Guanidines; Lithium; Lithium Chloride; Lithium Compounds; Perchlorates; Solubility; Surface Tension; Urea; Water