indigo-carmine and titanium-dioxide

The Indigo carmine (IC) dye has been widely used in textile industries, even though it has been considered toxic for rats, pigs and humans. Owing to its toxicity, wastes containing this compound should be treated to minimize or eliminate their toxic effects on the biota. As an alternative to wastewater treatment, advanced oxidative processes (AOPs) have been highlighted due to their high capacity to destruct organic molecules. In this context, this study aimed to evaluate Indigo Carmine toxicity to soil organisms using the earthworm Eisenia andrei as a model-organism and also verify the efficiency of AOP in reducing its toxicity to these organisms. To this end, lethal (mortality) and sub-lethal (loss or gain of biomass, reproduction, behavior, morphological changes and immune system cells) effects caused by this substance and its degradation products in these annelids were evaluated. Morphological changes were observed even in organisms exposed to low concentrations, while mortality was the major effect observed in individuals exposed to high levels of indigo carmine dye. The organisms exposed to the IC during the contact test showed mortality after 72h of exposure (LC

Topics: Animals; Avoidance Learning; Behavior, Animal; Biomass; Catalysis; Indigo Carmine; Lethal Dose 50; Oligochaeta; Oxidation-Reduction; Reproduction; Soil; Soil Pollutants; Time Factors; Titanium; Toxicity Tests

In this study highly efficient photocatalyst based on composite nanofibers containing polyacrylonitrile (PAN), carbon nanotubes (CNT), and surface functionalized TiO2 nanoparticles was developed. The composite nanofibers were fabricated using electrospinning technique followed by chemical crosslinking. The surface modification and morphology changes of the fabricated composite nanofibers were examined through SEM, TEM, and FTIR analysis. The photocatalytic performance of the composite nanofibers for the degradation of model molecules, methylene blue and indigo carmine, under UV irradiation in aqueous solutions was investigated. The results demonstrated that high photodegradation efficiency was obtained in a short time and at low power intensity compared to other reported studies. The effective factors on the degradation of the dyes, such as the amount of catalyst, solution pH and irradiation time were investigated. The experimental kinetic data were fitted using pseudo-first order model. The effect of the composite nanofibers as individual components on the degradation efficiency of MB and IC was evaluated in order to understand the overall photodegradation mechanism. The results obtained showed that all the components possess significant effect on the photodegradation activity of the composite nanofibers. The stability studies demonstrated that the photodegradation efficiency can remain constant at the level of 99% after five consecutive cycles.

Topics: Acrylic Resins; Catalysis; Coloring Agents; Indigo Carmine; Methylene Blue; Molecular Structure; Nanocomposites; Nanofibers; Nanotubes, Carbon; Oxidation-Reduction; Photolysis; Titanium; Ultraviolet Rays; Wastewater; Water Pollutants, Chemical; Water Purification

Applications of carbon-TiO2 materials have attracted attention in nanotechnology due to their synergic effects. We report the immobilization of TiO2 on carbon prepared from residues of the plant Manihot, commercial TiO2 and glycerol. The objective was to obtain a moderate loading of the anatase phase by preserving the carbonaceous external surface and micropores of the composite. Two preparation methods were compared, including mixing dry precursors and immobilization using a glycerol slurry. The evaluation of the micropore blocking was performed using nitrogen adsorption isotherms. The results indicated that it was possible to use Manihot residues and glycerol to prepare an anatase-containing material with a basic surface and a significant SBET value. The activities of the prepared materials were tested in a decomposition assay of indigo carmine. The TiO2/carbon eliminated nearly 100% of the dye under UV irradiation using the optimal conditions found by a Taguchi L4 orthogonal array considering the specific surface, temperature and initial concentration. The reaction was monitored by UV-Vis spectrophotometry and LC-ESI-(Qq)-TOF-MS, enabling the identification of some intermediates. No isatin-5-sulfonic acid was detected after a 60 min photocatalytic reaction, and three sulfonated aromatic amines, including 4-amino-3-hydroxybenzenesulfonic acid, 2-(2-amino-5-sulfophenyl)-2-oxoacetic acid and 2-amino-5-sulfobenzoic acid, were present in the reaction mixture.

Topics: Carbon; Coloring Agents; Indigo Carmine; Manihot; Photolysis; Titanium; Ultraviolet Rays

In this work, a co-doped Bi-Zn-TiO₂ photocatalist is synthesized by an original synthesis route of layered double hydroxide followed by heat treatment at 670 °C. After characterization the photocatalyst efficiency is estimated by the photo-discoloration of an anionic dye (indigo carmine) under visible light and compare to TiO₂-P25 as reference material. In this new photocatalyst, anatase and ZnO wurtzite are the only identified crystalline phase, rutile and Bi₂O₃ being undetected. Moreover, the binding energy of Bi determined (XPS analysis) is different from the one of Bi in Bi₂O₃. Compared to TiO₂-P25, the absorption is red shifted (UV-vis DRS) and the Bi-Zn-TiO₂ photocatalyst showed sorption capacity toward indigo carmine higher than that TiO₂-P25. The kinetics of the photo-discoloration is faster with Bi-Zn-TiO₂ than with TiO₂-P25. Indeed, a complete discoloration is obtained after 70 min and 120 min in the presence of Bi-Zn-TiO₂ and TiO₂-P25 respectively. The identification of the responsible species on photo-discoloration was carried out in the presence of different scavengers. The study showed that the first responsible is h(+) specie with a moderate contribution of superoxide anion radical and a minor contribution of the hydroxyl radical. The material showed high stability after five uses with the same rate of photo-discoloration.

Topics: Bismuth; Catalysis; Coloring Agents; Equipment Reuse; Hydroxides; Indigo Carmine; Light; Photochemistry; Spectrophotometry, Ultraviolet; Surface Properties; Titanium; Zinc

New assays with HepG2 cells indicate that Indigo Carmine (IC), a dye that is widely used as additive in many food and pharmaceutical industries exhibited cytotoxic effects. This work describes the development of a bicomponent nanostructured Ti/TiO2/WO3 electrode prepared by "template" method and investigates its efficiency in a photoelectrocatalytic method by using visible light irradiation and applied potential of 1V. After 2h of treatment there are reduction of 97% discoloration, 62% of mineralization and formation of three byproducts assigned as: 2-amine-5-sulfo-benzoic acid, 2,3-dioxo-14-indole-5-sulfonic acid, and 2-amino-α-oxo-5-sulfo-benzeneacetic acid were identified by HPLC-MS/MS. But, cytotoxicity was completely removed after 120 min of treatment.

Topics: Electrodes; Indigo Carmine; Indoles; Models, Chemical; Nanostructures; Oxides; Photochemical Processes; Titanium; Tungsten; Water Pollutants, Chemical; Water Purification

Indigo carmine and methylene blue dyes in aqueous solution were photodegraded using SiC-TiO(2) catalysts prepared by sol-gel method. After thermal treatment at 450°C, SiC-TiO(2) catalysts prepared in this work showed the presence of SiC and TiO(2) anatase phase. Those compounds showed specific surface area values around 22-25 m(2)g(-1), and energy band gap values close to 3.05 eV. In comparison with TiO(2) (P25), SiC-TiO(2) catalysts showed the highest activity for indigo carmine and methylene blue degradation, but this activity cannot be attributed to the properties above mentioned. Therefore, photocatalytic performance is due to the synergy effect between SiC and TiO(2) particles caused by the sol-gel method used to prepare the SiC-TiO(2) catalysts. TiO(2) nanoparticles are well dispersed onto SiC surface allowing the transfer of electronic charges between SiC and TiO(2) semiconductors, which avoid the fast recombination of the electron-hole pair during the photocatalytic process.

Topics: Carbon Compounds, Inorganic; Catalysis; Indigo Carmine; Methylene Blue; Microscopy, Electron, Scanning; Photochemical Processes; Silicon Compounds; Solutions; Titanium; Water; X-Ray Diffraction

A new method for the preparation of rubber sheet strewn with titanium dioxide particles (TiO2-strewn sheet) is presented. This simple and low cost method is based on the use of TiO2 powder (Degussa P25) being strewn onto the sheet made from rubber latex (60% HA) through a steel sieve. The characteristic of the TiO2-strewn sheet was studied by using scanning electron microscopy/energy dispersive X-ray spectrometer (SEM/EDS) and X-ray diffractometer (XRD) techniques. The photocatalytic activity of TiO2-strewn rubber sheet was evaluated using Indigo Carmine (IC) dye as a model for organic dye pollutant in water. The results showed that the TiO2-strewn sheet could degrade IC dye solution under UV light irradiation. The effects of pH, initial concentration, and the intensity of UV light on the photodegradation were also investigated. Kinetics of the photocatalytic degradation was of the first-order reaction. The used TiO2-strewn sheet can be recovered and reused. The recycling uses did not require any cleaning between successive uses and no decline in the photodegradation efficiency was observed compared with freshly prepared TiO2-strewn sheet.

Topics: Catalysis; Coloring Agents; Indigo Carmine; Light; Microscopy, Electron, Scanning; Molecular Structure; Recycling; Rubber; Titanium; Water; Water Pollutants, Chemical; Water Purification

In this work, we report in situ studies of UV photoelectrocatalytic discoloration of a dye (indigo carmine) by a TiO(2) thin film in a microreactor to demonstrate the driving force of the applied electrode potential and the dye flow rate toward dye discoloration kinetics.. TiO(2) 65-nm-thick thin films were deposited by PVD magnetron sputtering technique on a conducting glass substrate of fluorinated tin oxide. A microreactor to measure the discoloration rate, the electrode potential, and the photocurrent in situ, was developed. The dye solutions, before and after measurements in the microreactor, were analyzed by Raman spectroscopy.. The annealed TiO(2) thin films had anatase structure with preferential orientation (101). The discoloration rate of the dye increased with the applied potential to TiO(2) electrode. Further, acceleration of the photocatalytic reaction was achieved by utilizing dye flow recirculation to the microreactor. In both cases the photoelectrochemical/photocatalytic discoloration kinetics of the dye follows the Langmuir-Hinshelwood model, with first-order kinetics.. The feasibility of dye discoloration on TiO(2) thin film electrodes, prepared by magnetron sputtering using a flow microreactor system, has been clearly demonstrated. The discoloration rate is enhanced by applying a positive potential (E (AP)) and/or increasing the flow rate. The fastest discoloration and shortest irradiation time (50 min) produced 80% discoloration with an external anodic potential of 0.931 V and a flow rate of 12.2 mL min(-1).

Topics: Indigo Carmine; Photolysis; Titanium; Ultraviolet Rays; Water Pollutants, Chemical

The current research work focuses on the combination of photocatalytic and sonocatalytic (sonophotocatalytic) degradation of anionic dyes, viz., Orange G, Remazol Brilliant Blue R, Alizarin Red S, Methyl Blue, and Indigo Carmine, with solution combustion synthesized TiO2 (CS TiO2) and commercial Degussa P-25 TiO2 (DP-25). The rate of sonophotocatalytic degradation of all the dyes and the reduction of total organic carbon was higher compared to the individual photo- and sonocatalytic processes. The effect of dissolved gases and ultrasonic intensity on the sonophotocatalytic degradation of the dyes was evaluated. A dual-pathway network mechanism of sonophotocatalytic degradation was proposed for the first time, and the rate equations were modeled using the network reduction technique. The kinetic rate coefficients of the individual steps were evaluated for all the systems by fitting the model with experimental data.

Topics: Anions; Anthraquinones; Azo Compounds; Benzenesulfonates; Catalysis; Coloring Agents; Indigo Carmine; Kinetics; Models, Chemical; Nanoparticles; Photochemical Processes; Sonication; Titanium

The photocatalytic degradation of indigo carmine has been investigated in aqueous solutions using TiO2 coated non-woven fibres as photocatalyst. The experiments were carried out to investigate the factors influencing the photocatalytic degradation, such as the previous adsorption in the dark, initial concentration of dye solution, temperature, and pH. The experimental results show that adsorption is an important parameter controlling the apparent kinetic constant of the degradation. The photocatalytic degradation rate was favoured by a high concentration of solution in respect to Langmuir-Hinshelwood model. The degradation rate was pH and temperature dependent with a high degradation rate at high temperature.

Topics: Adsorption; Catalysis; Hydrogen-Ion Concentration; Indigo Carmine; Kinetics; Photochemistry; Solutions; Temperature; Titanium

The photodegradation of various dyes in aqueous solution was studied. Experiments were carried out using glass coated titanium dioxide thin film as photocatalyst. Photodegradation processes of methylene blue (MB), methyl orange (MO), indigo carmine (IC), chicago sky blue 6B (CSB), and mixed dye (MD, mixture of the four mentioned single dye) were reported. As each photodegradation system is pH dependent, the photodegradation experiment was carried out in each dye photodegradation reactive pH range at approximately 28 degrees C. The dyes removal efficiency was studied and compared using UV-vis spectrophotometer analysis. The total removal of each dye was: methylene blue (90.3%), methyl orange (98.5%), indigo carmine (92.4%), chicago sky blue 6B (60.3%), and mixed dyes (70.1%), respectively. The characteristic of the photocatalyst was investigated using X-ray diffractometer (XRD). The amount of each dye intermediate produced in the photodegradation process was also determined with the help of total organic carbon (TOC) analysis.

Topics: Azo Compounds; Coloring Agents; Fluorescence; Hydrogen-Ion Concentration; Indigo Carmine; Methylene Blue; Photochemistry; Titanium; Trypan Blue; Water; Water Pollutants, Chemical; Water Pollution, Chemical; X-Ray Diffraction