fluticasone and stearic-acid

Since carrier-based dry powder inhalers (DPIs) suffer from inadequate drug deposition in the lung, an increasing number of marketed products have added magnesium stearate (MgSt) to improve the aerosolization, dispersion, and stability against moisture of DPI. However, for carrier-based DPI, there is a lack of examination of the optimal MgSt content as well as the mixing modality, and there is also a need to verify the applicability of rheological properties to predict the in vitro aerosolization of DPI formulations containing MgSt. Therefore, in this work, DPI formulations were prepared using fluticasone propionate as a model drug and commercial crystalline lactose Respitose® SV003 as a carrier within 1% MgSt content, the effect of MgSt content on the rheological and aerodynamic properties were investigated. After the optimal MgSt content was determined, the effects of mixing modality, mixing order, and carrier size on formulation properties were further investigated. Meanwhile, correlations were established between rheological parameters and in vitro drug deposition parameters, and the contribution of rheological parameters were determined using principal component analysis (PCA). The results showed that the optimal content of MgSt in DPI formulations is 0.25%-0.5% under both high-shear and low-shear, using medium-sized carriers (D50 around 70 μm) and low-shear mixing are beneficial for improving in vitro aerosolization. Good linear relationships between powder rheological parameters such as basic flow energy (BFE), specific energy (SE), Permeability and fine particle fraction (FPF) were established, PCA showed that both flowability and adhesion are key properties affecting FPF. In conclusion, both MgSt content and mixing modality can influence rheological properties of the DPI, which can be used as a screeing tool for DPI formuluation and preparation process optimization.

Topics: Administration, Inhalation; Aerosols; Drug Carriers; Dry Powder Inhalers; Fluticasone; Lactose; Particle Size; Powders

In this study, we evaluated the aerodynamic performance, dissolution, and permeation behavior of micronized fluticasone propionate (FP) and magnesium stearate (MgSt) binary mixtures. Micronized FP was dry mixed with 2% w/w MgSt using a tumble mixer and a resonant acoustic mixer (RAM) with and without heating. The mixing efficacy was determined by X-ray powder diffraction (XRPD) and differential scanning calorimetry (DSC) analysis. Additional techniques were used to determine powder properties such as the dynamic vapor sorption (DVS), particle size distribution (PSD) by laser diffraction light scattering, and particle surface properties by scanning electron microscope (SEM). The aerodynamic performance was studied by the next-generation impactor (NGI) using drug-loaded capsules in a PlastiApi® device. Physiochemical properties such as porosity, particle size distribution, and surface area of the formulations were studied with adsorption and desorption curves fitted to several well-known models including Brunauer-Emmett-Teller (BET), Barret Joyner Halenda (BJH), and the density functional theory (DFT). The dissolution behavior of the formulations collected on the transwell inserts incorporated into stages 3, 5, and 7 of the NGI with a membrane providing an air interface was evaluated. Drug permeability of formulations was assessed by directly depositing particles on Calu-3 cells at the air-liquid interface (ALI). Drug concentration was determined by LC-MS/MS. A better MgSt mixing on micronized FP particles was achieved by mixing with a RAM with and without heating than with a tumble mixer. A significant concomitant increase in the % of emitted dose and powder aerosol performance was observed after MgSt mixing. Formulation 4 (RAM mixing at room temperature) showed the highest rate of permeability and correlation with dissolution profile. The results show that the surface enrichment of hydrophobic MgSt improved aerosolization properties and the dissolution and permeability rate of micronized FP by reducing powder agglomerations. A simple low-shear acoustic dry powder mixing method was found to be efficient and substantially improved the powder aerosolization properties and enhanced dissolution and permeability rate.

Topics: Administration, Inhalation; Aerosols; Chromatography, Liquid; Dry Powder Inhalers; Fluticasone; Particle Size; Permeability; Powders; Stearic Acids; Surface Properties; Tandem Mass Spectrometry