ferrihydrite and manganese-dioxide

All-solid-state, flexible, symmetric, and asymmetric microsupercapacitors are fabricated by a simple method in a scalable fashion from laser-induced graphene on commercial polyimide films, followed by electrodeposition of pseudocapacitive materials on the interdigitated in-plane architectures. These microsupercapacitors demonstrate comparable energy density to commercial lithium thin-film batteries, yet exhibit more than two orders of magnitude higher power density with good mechanical flexibility.

Topics: Electric Capacitance; Electrochemical Techniques; Ferric Compounds; Graphite; Lasers, Gas; Manganese Compounds; Oxides; Resins, Synthetic

Persulfate (S2O8(2-)) is being used increasingly for in situ chemical oxidation (ISCO) of organic contaminants in groundwater, despite an incomplete understanding of the mechanism through which it is converted into reactive species. In particular, the decomposition of persulfate by naturally occurring mineral surfaces has not been studied in detail. To gain insight into the reaction rates and mechanism of persulfate decomposition in the subsurface, and to identify possible approaches for improving its efficacy, the decomposition of persulfate was investigated in the presence of pure metal oxides, clays, and representative aquifer solids collected from field sites in the presence and absence of benzene. Under conditions typical of groundwater, Fe(III)- and Mn(IV)-oxides catalytically converted persulfate into sulfate radical (SO4(•-)) and hydroxyl radical (HO(•)) over time scales of several weeks at rates that were 2-20 times faster than those observed in metal-free systems. Amorphous ferrihydrite was the most reactive iron mineral with respect to persulfate decomposition, with reaction rates proportional to solid mass and surface area. As a result of radical chain reactions, the rate of persulfate decomposition increased by as much as 100 times when benzene concentrations exceeded 0.1 mM. Due to its relatively slow rate of decomposition in the subsurface, it can be advantageous to inject persulfate into groundwater, allowing it to migrate to zones of low hydraulic conductivity where clays, metal oxides, and contaminants will accelerate its conversion into reactive oxidants.

Topics: Benzene; Environment; Ferric Compounds; Groundwater; Hydrogen-Ion Concentration; Manganese Compounds; Minerals; Oxidation-Reduction; Oxides; Phenols; Sulfates; Water Pollutants, Chemical; Water Pollution

The impact of four electron acceptors on hydrocarbon-induced methanogenesis was studied. Methanogenesis from residual hydrocarbons may enhance the exploitation of oil reservoirs and may improve bioremediation. The conditions to drive the rate-limiting first hydrocarbon-oxidizing steps for the conversion of hydrocarbons into methanogenic substrates are crucial. Thus, the electron acceptors ferrihydrite, manganese dioxide, nitrate or sulfate were added to sediment microcosms acquired from two brackish water locations. Hexadecane, ethylbenzene or 1-(13)C-naphthalene were used as model hydrocarbons. Methane was released most rapidly from incubations amended with ferrihydrite and hexadecane. Ferrihydrite enhanced only hexadecane-dependent methanogenesis. The rates of methanogenesis were negatively affected by sulfate and nitrate at concentrations of more than 5 and 1 mM, respectively. Metal-reducing Geobacteraceae and potential sulfate reducers as well as Methanosarcina were present in situ and in vitro. Ferrihydrite addition triggered the growth of Methanosarcina-related methanogens. Additionally, methane was removed concomitantly by anaerobic methanotrophy. ANME-1 and -2 methyl coenzyme M reductase genes were detected, indicating anaerobic methanotrophy as an accompanying process [Correction added 16 December after online publication: 'methyl coenzyme A' changed to 'methyl coenzyme M' in this sentence]. The experiments presented here demonstrate the feasibility of enhancing methanogenic alkane degradation by ferrihydrite or sulfate addition in different geological settings.

Topics: Anaerobiosis; Belgium; Biodegradation, Environmental; Carbon Dioxide; Ferric Compounds; Geobacter; Geologic Sediments; Hydrocarbons, Acyclic; Hydrocarbons, Aromatic; Iron; Manganese Compounds; Methane; Methanosarcina; Molecular Sequence Data; Nitrates; Oxidation-Reduction; Oxides; Sulfates; Time Factors