docusate-sodium and ethylene-dichloride

Voltammetric behaviors of various globular proteins, including cytochrome c, ribonuclease A, lysozyme, albumin, myoglobin, and alpha-lactalbumin, were studied at the polarized 1,2-dichloroethane/water (DCE/W) interface in the presence of four different anionic surfactants, that is, dinonylnaphthalenesulfonate (DNNS), bis(2-ethylhexyl)sulfosuccinate (Aerosol-OT; AOT), bis(2,2,3,3,4,4,5,5,6,6,7,7-dodecafluoroheptyl)sulfosuccinate (BDFHS), and bis(2-ethylhexyl)phosphate (BEHP). When the W phase was acidic (pH = approximately 3.4), the surfactants (except for BEHP) added to DCE facilitated the adsorption of the above proteins to the DCE/W interface and gave a well-developed voltammetric wave due to the adsorption/desorption of the proteins. This voltammetric wave, which we here call "protein wave", is promising for direct label-free electrochemical detection of proteins. The current for the adsorption of a protein to the interface showed a linear dependence on the protein concentration in the presence of excess surfactant. The foot potential at which the protein wave appeared in cyclic voltammetry showed different values depending on the natures of the protein and surfactant. Multivariate analysis for the foot potentials determined for different proteins with different surfactants revealed that the protein selectivity should depend on the charged, polar, and nonpolar surface areas of a protein molecule. On the basis of these voltammetric studies, it was shown in principle that online electrochemical separation/determination of proteins could be performed using a two-step oil/water-type flow-cell system.

Topics: Electrochemistry; Ethylene Dichlorides; Models, Theoretical; Muramidase; Myoglobin; Oils; Proteins; Succinates; Surface-Active Agents; Water

The transfer of proteins by the anionic surfactant bis(2-ethylhexyl) sulfosuccinate (AOT) at a polarized 1,2-dichloroethane/water (DCE/W) interface was investigated by means of ion-transfer voltammetry. When the tetrapentylammonium salt of AOT was added to the DCE phase, the facilitated transfer of certain proteins, including cytochrome c (Cyt c), ribonuclease A, and protamine, could be controlled electrochemically, and a well-defined anodic wave for the transfer was obtained. At low pH values (e.g., pH 3.4), the anodic wave was usually well-separated from the wave for the formation of protein-free (i.e., unfilled) reverse micelles. The anodic wave for the protein transfer was analyzed by applying the theory for facilitated transfer of ions by charged ligands and then supplying information regarding the number of AOT anions reacting with one protein molecule and the total charge carried by the protein transfer. However, controlled-potential electrolyses performed for the transfer of Cyt c, which is red, revealed that the protein-AOT complexes were unstable in DCE and liable to aggregate at the interface when the pH of the W phase was 3.4. At pH 7.0, when formation of unfilled reverse micelles occurred simultaneously, the protein-AOT complexes appeared to be stabilized, probably via fusion with unfilled reverse micelles.

Topics: Animals; Cytochromes c; Electrochemistry; Electrolysis; Ethylene Dichlorides; Hydrogen-Ion Concentration; Micelles; Protamines; Proteins; Ribonuclease, Pancreatic; Succinates; Surface-Active Agents; Water