clay and ethylene

Interest in using contaminant mass discharge (CMD) for risk assessment of contaminated sites has increased over the years, as it accounts for the contaminant mass that is moving and posing a risk to water resources and receptors. The most common investigation of CMD involves a transect of multilevel wells; however, this is an expensive undertaking, and it is difficult to place it in the right position in a plume. Additionally, infrastructure at the site needs to be considered. To derive an initial CMD estimate at a contaminated site and to allow for the prioritization of further investigations and remedial actions, the ProfileFlux method has been developed. It is targeted at former industrial sites with a source zone in a low conductivity layer with primarily vertical flow overlying an aquifer with primarily horizontal groundwater flow. The ProfileFlux method was developed for mature chlorinated solvent plumes, typically originating from more than 30 to 50-year-old spills, as the usage of chlorinated solvents is primarily historical. Thus, it is assumed that the contaminant had time to distribute in the low conductivity layer by mainly diffusive processes. Today the contamination is continuously released to the underlying aquifer, where advection and dispersive (other than diffusive) processes are of higher importance. The approach combines high-resolution, depth-discrete vertical concentration profiles and a simple 2D flow and transport model to estimate CMD by comparing measured and simulated concentration profiles. The study presented herein includes a global sensitivity analysis, in order to identify crucial field parameters, and of particular importance in this regard are source length, groundwater flux and infiltration. The ProfileFlux method was tested at a well-examined industrial site primarily contaminated with trichloroethylene, thereby allowing a comparison between CMD from the ProfileFlux method and the traditional transect method. CMD was estimated at 117-170 g/year, when using the ProfileFlux method, against 143 g/year with the transect method, thus validating ProfileFlux method's ability to estimate CMD. In addition, applying the method identified weak points in the conceptual site model. The method will be incorporated into a user-friendly online tool directed at environmental consultants and decision-makers working on the risk assessment and prioritization of contaminated sites with the specific hydrogeological conditions of an aquifer w

Topics: Clay; Groundwater; Solvents; Trichloroethylene; Water Pollutants, Chemical

This study presents a process-based modeling analysis of electrokinetic-enhanced bioremediation (EK-Bio) to illuminate the complex interactions between physical, electrostatic and biogeochemical processes occurring during the application of this remediation technique. The features of the proposed model include: (i) multidimensional electrokinetic transport in saturated porous media by electromigration and electroosmosis, (ii) charge interactions, (iii) degradation kinetics, (iv) microbial populations dynamics of indigenous and specialized exogenous degraders, (v) mass transfer limitations, and (vi) geochemical reactions. A scenario modeling investigation is presented, which was inspired by an EK-Bio pilot application conducted in a clayey aquitard at the Skuldelev site (Denmark) contaminated by chlorinated ethenes. Lactate and specialized degraders are delivered under conservative and reactive transport conditions. In the considered setup, transport of lactate using electrokinetics results in more than fourfold increase in the distribution efficiency with respect to a diffusion-only scenario. Moreover, EK transport by electromigration and electroosmosis yields fluxes at least two orders of magnitude larger than diffusive fluxes. Quantitative metrics are also defined and used to assess the amendment distribution and the enhanced contaminant biodegradation in the different conservative and reactive transport scenarios.

Topics: Biodegradation, Environmental; Clay; Environmental Restoration and Remediation; Ethylenes

In the present study, the catalytic dehydration of ethanol to obtain ethylene over montmorillonite clays (MMT) with mineral acid activation including H2SO4 (SA-MMT), HCl (HA-MMT) and HNO3 (NA-MMT) was investigated at temperature range of 200 to 400°C. It revealed that HA-MMT exhibited the highest catalytic activity. Ethanol conversion and ethylene selectivity were found to increase with increased reaction temperature. At 400°C, the HA-MMT yielded 82% of ethanol conversion having 78% of ethylene yield. At lower temperature (i.e. 200 to 300°C), diethyl ether (DEE) was a major product. The highest activity obtained from HA-MMT can be attributed to an increase of weak acid sites and acid density by the activation of MMT with HCl. It can be also proven by various characterization techniques that in most case, the main structure of MMT did not alter by acid activation (excepted for NA-MMT). Upon the stability test for 72 h during the reaction, the MMT and HA-MMT showed only slight deactivation due to carbon deposition. Hence, the acid activation of MMT by HCl is promising to enhance the catalytic dehydration of ethanol.

Topics: Aluminum Silicates; Bentonite; Catalysis; Clay; Desiccation; Drug Stability; Ethanol; Ethylenes; Hot Temperature; Hydrochloric Acid; Nitric Acid; Sulfuric Acids; Time Factors

A molecular study on how the abundance of the dechlorinating culture KB-1 affects dechlorination rates in clay till is presented. DNA extracts showed changes in abundance of specific dechlorinators as well as their functional genes. Independently of the KB-1 added, the microbial dechlorinator abundance increased to the same level in all treatments. In the non-bioaugmented microcosms the reductive dehalogenase gene bvcA increased in abundance, but when KB-1 was added the related vcrA gene increased while bvcA genes did not increase. Modeling showed higher vinyl-chloride dechlorination rates and shorter time for complete dechlorination to ethene with higher initial concentration of KB-1 culture, while cis-dichloroethene dechlorination rates were not affected by KB-1 concentrations. This study provides high resolution abundance profiles of Dehalococcoides spp. (DHC) and functional genes, highlights the ecological behavior of KB-1 in clay till, and reinforces the importance of using multiple functional genes as biomarkers for reductive dechlorination.

Topics: Aluminum Silicates; Biodegradation, Environmental; Clay; DNA, Bacterial; Ethylenes; Halogenation; Kinetics; Models, Chemical; Soil Microbiology; Soil Pollutants; Vinyl Chloride

The performance of enhanced reductive dechlorination (ERD) for in situ remediation of cis-1,2-dichloroethene (cDCE) and vinyl chloride in clayey till was investigated in a pilot test. A dilute groundwater solution containing emulsified soybean oil and Dehalococcoides bacteria was injected into a sand-filled hydraulic fracture. Fermentation of the ERD solution caused the establishment of a dechlorinating bioactive zone in the fracture within 1 month of injection. By 148 days, all the cDCE in the fracture was dechlorinated to ethene. Analysis of a clay core from Day 150 indicated that electron donor and fermentation products diffused from the fracture at least 10 cm into clay and that stimulated dechlorination occurred in the clay in the presence of Dehalococcoides (7.9.10(4) cells g(-1)). Comparison of chloroethene profiles in the Day 150 core to modeled diffusion profiles indicated degradation occurred in a bioactive zone extending approximately 5 to 6 cm into the clay matrix. These data suggest that a bioactive zone established in a sand-filled fracture can expand into the adjacent clayey till matrix and facilitate mass transfer from the matrix to the bioactive zone. These findings offer promise for ERD and support further development of methods for deploying ERD in clayey till and other low-permeability deposits.

Topics: Aluminum Silicates; Biodegradation, Environmental; Chlorine; Chloroflexi; Clay; Dose-Response Relationship, Drug; Electrons; Environmental Monitoring; Environmental Restoration and Remediation; Ethylenes; Fermentation; Oxidation-Reduction; Permeability; Time Factors